Casino Plus app

The Casino Plus appengine rod is an important part of the engine. Its function is to connect the piston with the crankshaft to transmit the power of the engine. The operation of the engine rod is quite frequent and also under considerable pressure, so its failure often affects the operation of the whole engine, and how to detect and repair the engine rod failure has also become one of the knowledge that every car owner must master.1. How to detect the fault of the engine rod? Engine rod failure is mainly manifested in the following two situations: Situation 1: Engine noise. When the engine rod has problems such as wear or fatigue breakage, friction or collision noise will occur. At this time, you can open the hood and shake the engine by hand to listen to whether there is any abnormal noise. If you find that the noise is more obvious, it may be a problem with the engine lever. Situation 2: Increased fuel consumption and decreased power. When the engine lever is worn or deformed, it will lead to a decline in engine performance. If you find that fuel consumption increases and the power of the car decreases, there may be a problem with the engine lever. Two. How to repair the engine rod failure? Before repairing the engine rod, the entire engine needs to be disassembled before it can enter the interior for maintenance.Generally speaking, the repair of the engine rod is divided into the following steps: Step 1: Check the condition of the engine rod. Before maintenance, a comprehensive inspection of the condition of the engine rod is required. Find the cause of the failure of the engine rod. If it is worn, we need to grind it in time; if it is broken or deformed, we need to replace the engine rod. Step 2: Repair the engine lever. When it is determined that the engine lever needs to be replaced, we need to disassemble and place the tool clearly on the toolboard for subsequent use. Then use appropriate tools to remove the old engine rod and install the new engine rod. In this process, special attention should be paid to the need to accurately match the crankshaft after the replaced engine rod. Step 3: Reassemble the whole engine. After replacing the engine rod, you need to reassemble the wholeWhen assembling the engine, it is necessary to pay attention to the order and position of each accessory, so that the whole engine generates minimal resistance when working normally and improve the efficiency and service life of the engine. Step 4: After completing the adjustment and assembly of the whole engine, a test drive is required. During the test drive, we need to pay attention to carefully observe the operating status of each engine in order to find faults and repair them in time. In summary, the engine rod is an important part of the engine, and its failure will affect the operation of the whole engine. Therefore, when we find a problem, we need to check and repair it in time. At the same time, we need to follow the correct operation process and skills when repairing and maintaining. Only in this way can we ensure the normal operation of the whole engine and extend its life.

Contact Us
Phone：020-83484669